Serial Interface Remote Communication Via Modem; Table 3-4 Communication Component List - Cisco 15216 EDFA2 Operation Manual

Cisco systems optical network system operations guide
Table of Contents

Advertisement

Chapter 3
Installation

3.5.4 Serial Interface Remote Communication via Modem

This section describes the procedure for establishing a remote dial-up connection to the
ONS 15216 EDFA2. ONS 15216 EDFA2 remote communication requires two US Robotics 56K Fax
modems set up to send data over a two-wire dial-up telephone line. (See
This section assumes the use of the US Robotics 56K Fax modem V.90. Other modem types may require
different settings to establish a remote dial-up connection. The user should review their modem
documentation to ensure compatibility between US Robotics and other vendor modem types.
Figure 3-7
Workstation
3.5.4.1 Remote Communication Component Requirements
Table 3-4
is divided into two sections: Remote Site and Local Site. The Remote Site section lists components
needed at the site that contains the ONS 15216 EDFA2 and the Local Site section lists components
needed at the site where the user is located.
Table 3-4
Component
Remote Site
1 ONS 15216 EDFA2
1 US Robotics 56K Fax modem V.90
1 10-ft DB-25M to DB-9F cable
1 RJ-11 to RJ-11 telephone cable
1 public switched telephone network
(PSTN) dial-up telephone line
Local Site
1 PC running HyperTerminal
US Robotics 56K Fax modem V.90
1 10-ft DB-25M to DB-9F
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Remote Communication
Network
Modem
PSTN Dial up
Phone line
lists the components required to communicate remotely with a ONS 15216 EDFA2.
Communication Component List
Modem
Cisco ONS 15216
EDFA2
Notes
The modem to ONS 15216 EDFA2
connection must be set for 19200 baud.
The modem to modem connection must
be set for 14400 baud.
For connection between
ONS 15216 EDFA2 and modem.
For connection between the modem and
PSTN dial-up telephone line
The modem to ONS 15216 EDFA2
connection must be set for 19200 baud.
The modem to modem connection must
be set for 14400 baud.
For connection between PC COM port
and modem.
Cisco ONS 15216 EDFA2 Operations Guide
Communications
Figure
3-7.)
Table 3-4
3-11

Advertisement

Table of Contents
loading

Table of Contents