TL1 Commands and Autonomous Messages
9.7.43 RTRV-USER-SECU
Command
RTRV-USER-SECU
Retrieves the access level of an existing user from the system. Does not return the password.
Syntax
RTRV-USER-SECU:[<tid>]:<uid>:<ctag>;
<sid> <date> <time>
M
<ctag> COMPLD
"<uid>,<al>"
;
Example 9-46 RTRV-USER-SECU Command and Response
Amp01:ONS15216 EDFA2> RTRV-USER-SECU:Amp01:jsmith:123;
Amp01 2002-05-13 17:23:16
M
123 COMPLD
"jsmith,RW"
;
Table 9-50 RTRV-USER-SECU Syntax Description
Parameter
sid
al
uid
9.7.44 SET-ATTR-SECUDFLT
Command
SET-ATTR-SECUDFLT
Sets the timeout value of user sessions for users with a specific access level. If no communication occurs
for this time, the user session is closed by the ONS 15216 EDFA2 TL1 agent. Users affected by changes
to the timeout must log out and log in again for the change to take effect.
Syntax
SET-ATTR-SECUDFLT:[<tid>]::<ctag>::AL=<al>,TMOUT=<timeout>[,][,][,][,][,];
Cisco ONS 15216 EDFA2 Operations Guide
9-60
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
string
R
RW
RWA
string
Description
Source identifier uniquely identifies the source of a TL1
autonomous command.
Access level of the user. See
for TL1 Commands" section on page 9-6
permissions.
Read only privileges.
Read and write privileges.
Read, write, and administrative privileges.
User identifier (user name) of the existing user. If no user
identifier is specified and the current user has RWA access
level, it will list all existing users and their security levels.
Chapter 9
TL1 Commands
"Summary of Security Permissions
for access level
78-16033-01