Cisco 15216 EDFA2 Operation Manual page 187

Chapter 9 TL1 Commands
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Table 9-33 RTRV-ALM-EQPT Syntax Description (continued)
Parameter
condtype
date
ntfncde
ocrdat
ocrtm
sid
srveff
time
78-16033-01
Syntax Description
Condition type identifies the type of alarm (maps to
cerent15216EdfaLogEventID). Possible condtype and
corresponding conddescr (in quotes) are:
CTMP "Case Temperature Out of Range" alarm
(cerent15216EdfaAlarmCtmp).
LCRNT1 "Excessive Pump1 Current" alarm
(cerent15216EdfaAlarmLcrnt1).
LCRNT2 "Excessive Pump2 Current" alarm
(cerent15216EdfaAlarmLcrnt2).
LTMP1 "Excessive Pump1 Temperature" alarm
(cerent15216EdfaAlarmLtmp1).
LTMP2 "Excessive Pump2 Temperature" alarm
(cerent15216EdfaAlarmLtmp2).
yyyy-mm-dd Date of origination of TL1 message.
Notification code (maps to cerent15216EdfaAlarmPriority).
Possible values are:
CR Critical alarm.
MJ Major alarm.
MN Minor alarm.
CL Cleared alarm.
NA No alarm.
m-d Date (month-day) of the event occurrence (derived from
cerent15216EdfaDateAndTimeString).
h-m-s Time (hour-minute-second) of the event occurrence (derived
from cerent15216EdfaDateAndTimeString).
string Source identifier uniquely identifies the source of a TL1
autonomous command.
Effect on service. Possible values are:
SA Service affecting.
NSA Non-service affecting.
hh:mm:ss Time of origination of TL1 message.
TL1 Commands and Autonomous Messages
Cisco ONS 15216 EDFA2 Operations Guide
9-39