Rept Alm Env; Table 9-26 Rept Alm Env Syntax Description - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands

9.7.19 REPT ALM ENV

Command
REPT ALM ENV
Reports when a power bus alarm is logged or cleared (derived from cerent15216EdfaAlarmState).
Syntax
<sid> <date> <time>
<almcde> <atag> REPT ALM ENV
"<aid>:<ntfcncde>,<condtype>,<ocrdat>,<ocrtm>,<conddescr>"
;
Example 9-21 REPT ALM ENV Message
Amp01 2001-06-18 14:48:44
** 141 REPT ALM ENV
"PWR-A:MN,PWRBUSA,6-18,14-48-44,\"Power Bus A Alarm\""
;

Table 9-26 REPT ALM ENV Syntax Description

Parameter
almcde
atag
aid
conddescr
condtype
date
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
*C
**
*
A
0 - 999
PWR-A
PWR-B
PWRBUSA
PWRBUSB
yyyy-mm-dd
Description
The alarm severity code for the TL1 message. Possible values
are:
Critical alarm.
Major alarm.
Minor alarm.
No alarm. Occurs only when ntfncde is NA.
An integer between 0 and 999 used as a sequence number in
autonomous messages .
Possible values are:
Affecting Power Bus A (or both A and B).
Affecting Power Bus B.
Detailed text description of the event. The conddescr is 1 to 64
characters of ASCII text. See condtype below.
Condition type identifies the type of alarm (maps to
cerent15216EdfaLogEventID). Possible condtype and
corresponding conddescr (in quotes) are:
"Power Bus A (voltage) Alarm"
(cerent15216EdfaAlarmPowerBusA).
"Power Bus B (voltage) Alarm"
(cerent15216EdfaAlarmPowerBusB).
Date of origination of TL1 message.
Cisco ONS 15216 EDFA2 Operations Guide
TL1 Commands and Autonomous Messages
9-27