Cisco 15216 EDFA2 Operation Manual page 50

Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
If you see the login window shown in
Step 3
By default the ONS 15216 EDFA2 is in TL1 shell, so this step may be required to proceed in ASH shell.
When in TL1 shell, the screen opens to a simple prompt (
ASH shell, log in using the procedure in
section on page
Welcome to ONS15216 EDFA2 Console (v2.3.0)
sidtidname:ONS15216 EDFA2> ED-NE-GEN:::123:::CLI=ASH;
Then enter the following command at the hostname prompt:
sidtidname:ONS15216 EDFA2> INIT-SYS::ALL:1234::1;
The ONS 15216 EDFA2 should log you off and then bring up the ASH shell login window.
Check that the ONS 15216 EDFA2 login window appears as shown in
Step 4
Example 4-1
-- LOGIN ---------------------------------------------------- sysname
Enter both a user name and password.
Step 5
The default user name and password is CISCO15 with no password (press Enter).
For security reasons, it is recommended to change the password from its default value. See
Note
page 4-10
Press Enter when [Login] becomes highlighted.
Step 6
Example 4-2
Welcome to ONS15216 EDFA2 Console (v2.3.0)
ash:hostname:ONS15216 EDFA2>
An EIA/TIA-232 link to the ONS 15216 EDFA2 is established. The user can now provision the
ONS 15216 EDFA2.
Cisco ONS 15216 EDFA2 Operations Guide
4-2
8-1, and then enter the following command at the sid/tid name prompt:
ASH Shell Login Window
ONS15216 EDFA2 Optical Amplifier
--------------------------------
Software Version 2.3.0
Copyright (c) 2000-2003 Cisco Systems, Inc.
Username:
Password:
or Set Password, page 8-10.
ASH Shell Login Response
Chapter 4
Example 4-1 on page 4-2, skip to
sidtidname:ONS15216 EDFA2>
"Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal"
{ }
{ }
[Login]
Example 4-2 displays the login response.
Provisioning Using ASH and SNMP
Step 4.
). To change to
Example 4-1.
Set Password,
78-16033-01