Set Ip Address; Log In Via Lan Port Using Telnet (Optional) - Cisco 15216 EDFA2 Operation Manual

Chapter 4 Provisioning Using ASH and SNMP

4.2 Set IP Address

Before connecting the ONS 15216 EDFA2 to a LAN, it is mandatory to set the ONS 15216 EDFA2 IP
address through a local serial communication interface using the RS-232 (EIA/TIA-232) port on the
front of the module.
Step 1 If you do not know the ONS 15216 EDFA2's IP address, subnet mask, gateway address, or host name,
contact your network administrator.
At the command prompt, enter the snmp row set local cerent15216EdfaSromIpMgmtGroup
Step 2
command (displayed in
Example 4-3
ash:hostname:ONS15216 EDFA2> snmp row set local cerent15216EdfaSromIpMgmtGroup
cerent15216EdfaSromIpMgmtEnetAddress 0.0.0.0
cerent15216EdfaSromIpMgmtEnetSubNetMask 0.0.0.0
cerent15216EdfaSromIpMgmtDefaultRouterAddress 0.0.0.0
cerent15216EdfaSromIpMgmtHostName ""
Because row set is being used in this command, the user is prompted row by row to enter the IP address,
the subnet mask, the gateway address, and the host name (community ID).
Step 3 The changes must be saved prior to terminating the session. See
Step 4 The system must be rebooted to make the IP address active. Use the processor reset command. (See
"processor reset Command" section on page

4.3 Log In via LAN Port Using Telnet (Optional)

Provisioning of the ONS 15216 EDFA2 can be accomplished entirely through the RS-232
(EIA/TIA-232) port using CLI commands. After an IP address is assigned, it may be easier to provision
the ONS 15216 EDFA2 using Telnet or an SNMP manager. A Telnet client is needed for CLI commands
over IP. A generic SNMP manager is required for SNMP management over IP. After connecting the
ONS 15216 EDFA2 to the network through its RJ-45 LAN port (see
on page
the following procedure:
Connect to the LAN port on the front panel. See
Step 1
Click the Microsoft Windows Start menu and select Run.
Step 2
In the text field, type the following:
Step 3
telnet <ONS 15216 EDFA2 IP address> 8023
Specifying port 8023 ensures login through the ASH shell. If no port is specified, the
ONS 15216 EDFA2 responds in the shell that the ONS 15216 EDFA2 is set to. (TL1 is the default shell.)
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Example
Setting IP Address, Subnet Mask, Gateway Address, and Host Name
3-14), the user can configure the module to accept SNMP and CLI commands via Telnet using
4-3) and press Enter.
6-12.)
"LAN Connection Procedure" section on page
Cisco ONS 15216 EDFA2 Operations Guide
Set IP Address
"Save Changes" section on page
"LAN Interface (Ethernet)" section
4-11.
3-15.
4-3