Opgroup Table; Table 5-12 Cerent15216Edfaopgroup Variable Descriptions - Cisco 15216 EDFA2 Operation Manual

Tables and Groups
Table 5-11 cerent15216EdfaAlarmEntry Variable Descriptions (continued)
Variable
cerent15216EdfaAlarmEnable
Status
cerent15216EdfaAlarmDateAn
dTime

5.4.7 OpGroup Table

The cerent15216EdfaOpGroup table is used to display or set operation actions, such as saving
configuration or loading new software. The individual variables in
of the table command. That is, when performing a cutover command, the user would use the snmp
attribute set local cerent15216EdfaOpCutover perform command.

Table 5-12 cerent15216EdfaOpGroup Variable Descriptions

Variable
cerent15216EdfaOpStatus
cerent15216EdfaOpResult
cerent15216EdfaOpRequest
Id
cerent15216EdfaOpSaveCo
nfig
cerent15216EdfaOpCutover cerent15216EdfaActio
cerent15216EdfaOpLoad
Cisco ONS 15216 EDFA2 Operations Guide
5-20
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
cerent15216EdfaControl
cerent15216EdfaDateAndTime
String
Maximum
Syntax Access
cerent15216EdfaActio Read-only
nStatus
Integer Read-only
Integer Read-write The request identifier for this
cerent15216EdfaActio Read-write To save the configuration of the
n
Read-write When "perform" is written to this
n
cerent15216EdfaActio Read-write When "perform" is written to this
n
Chapter 5 SNMP MIB Installation and Configuration
Maximum
Access Description
Read-write If the alarm is
enabled/disabled.
Read-only The local date and time
when the alarm entered
its current state.
Table 5-12 are generally used instead
Description
The status of the current
operation.
This value is used to save the error
result (if any) of the last
operation. Success is indicated by
a value of 0.
operation. This is provided to
allow managers to match actions
and results.
optical module, write "perform"
to this object.
object, firmware is executed from
the current plane and the alternate
plane status is changed to the
default active plane.
object, new firmware is
downloaded. Before setting this
attribute, the source of the new
firmware should be specified by
setting
cerent15216EdfaOpSrcFileName
and
cerent15216EdfaOpTftpSrvAddr.
78-16033-01