Rtrv-Cond-Eqpt; Table 9-38 Rtrv-Cond-Eqpt Syntax Description - Cisco 15216 EDFA2 Operation Manual

TL1 Commands and Autonomous Messages

9.7.31 RTRV-COND-EQPT

Command
RTRV-COND-EQPT
Generates a report on the condition (state) of general alarms.
Syntax
RTRV-COND-EQPT:[<tid>]:<aid>:<ctag>::[<condtype>][,,,];
<sid> <date> <time>
M <ctag> COMPLD
"<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"
;
Example 9-33 RTRV-COND-EQPT Command and Response
Amp01:ONS15216 EDFA2> RTRV-COND-EQPT:Amp01:ALL:229::LCRNT1;
Amp01 2002-06-20 14:30:00
M 229 COMPLD
"EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""
;

Table 9-38 RTRV-COND-EQPT Syntax Description

Parameter
aid
conddescr
condtype
date
Cisco ONS 15216 EDFA2 Operations Guide
9-46
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
EQPT
ALL
CTMP
LCRNT1
LCRNT2
LTMP1
LTMP2
yyyy-mm-dd
Description
EQPT and ALL have same input effect.
General parameters of the ONS 15216 EDFA2 (not directly
affecting optical signal or power bus).
Any or all of the preceding (command input only).
Detailed text description of the event. The conddescr is 1 to 64
characters of ASCII text. See condtype below.
Condition type identifies the type of alarm (maps to
cerent15216EdfaLogEventID). Possible condtype and
corresponding conddescr (in quotes) are:
"Case Temperature Out of Range" alarm
(cerent15216EdfaAlarmCtmp).
"Excessive Pump1 Current" alarm
(cerent15216EdfaAlarmLcrnt1).
"Excessive Pump2 Current" alarm
(cerent15216EdfaAlarmLcrnt2).
"Excessive Pump1 Temperature" alarm
(cerent15216EdfaAlarmLtmp1).
"Excessive Pump2 Temperature" alarm
(cerent15216EdfaAlarmLtmp2).
Date of origination of TL1 message.
Chapter 9 TL1 Commands
78-16033-01