Dlt-Rfile; Table 9-14 Dlt-Rfile Syntax Description - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands
Table 9-13 CPY-MEM Syntax Description (continued)
Parameter
fromdev
tofile

9.7.7 DLT-RFILE

Command DLT-RFILE
Deletes a file from the flash file system (FFS) of the ONS 15216 EDFA2.
Syntax
DLT-RFILE:[<tid>]::<ctag>::FILE=<localfilename>;
Example 9-9
Amp01:ONS15216 EDFA2> DLT-RFILE:Amp01::1234::FILE=snmp.cfg;

Table 9-14 DLT-RFILE Syntax Description

Parameter
localfilename
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
DBCFG
MEM
FFS
CFG
any other string
DLT-RFILE Command
Syntax
string
Description
Device on which the source file exists. A null means MEM.
Possible values are:
ONS 15216 EDFA2 configuration parameters from IDROM,
CFGROM, RAM, and FFS.
ONS 15216 EDFA2 non-persistent memory (RAM).
ONS 15216 EDFA2 persistent memory (flash file system).
ONS 15216 EDFA2 system configuration in memory.
The system must be rebooted using INI-SYS for changes to the
system configuration to take effect.
The name string of the destination file. A null value is valid
only when fromfile is LOG or null and fromdev is MEM or null.
When null is valid, the system log file (LOG) is saved as
aolog.txt.
File names are case sensitive.
If copying from RAM (MEM) and the destination file name
already exists, the destination file is overwritten. If copying
from FFS and the destination file name already exists, the
execution fails.
Description
Name of the file on the flash file system of the
ONS 15216 EDFA2 that is to be deleted. File names are case
sensitive.
Cisco ONS 15216 EDFA2 Operations Guide
TL1 Commands and Autonomous Messages
9-15