Manufacturer Mode; Manufacturer Restore Defaults Passwords Command; Manufacturer Restore Defaults All Command - Cisco 15216 EDFA2 Operation Manual

Manufacturer Mode

6.10 Manufacturer Mode
A manufacturer mode enable command is available. It raises the root access level to the fifth and
highest manufacturer level to allow undocumented commands that are used only for manufacturing
purposes.
Warning Customers are strongly cautioned not to use this mode.

6.10.1 manufacturer restore defaults passwords Command

Command
manufacturer restore defaults passwords
Syntax Description manufacturer restore defaults passwords
Restores the manufacturing factory default passwords to the ONS 15216 EDFA2.
If the password for the CISCO15 user is lost and there are not other users with read_write_admin access
Note
level in the system, the password for CISCO15 can be reset by following the procedure in
Default Password" section on page

6.10.2 manufacturer restore defaults all Command

Command manufacturer restore defaults all
Syntax Description
manufacturer restore defaults all
Restores the manufacturing factory settings to the ONS 15216 EDFA2. The files on the flash file system
(FFS), the date and time, and the values of manufacturing calibration are not affected. This command
must be followed by the processor reset command to take effect.
Warning This command resets the IP address, resets the hostname, deletes the user directory, reverts CISCO15
to the default password, and resets other parameters to restore the unit to its state as shipped from
manufacturing.
Cisco ONS 15216 EDFA2 Operations Guide
6-32
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
4-14.
Chapter 6 ASH Commands
"Recover
78-16033-01