Rtrv-Cond-All; Table 9-35 Rtrv-Cond-All Syntax Description - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands

9.7.28 RTRV-COND-ALL

Command
RTRV-COND-ALL
Generates a report on the condition (state) of all alarms (except environmental alarms). Note that the ccm
does not appear in the response for EQPT alarms.
The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power
Note
(LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time.
For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at
the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering
of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.
Syntax
RTRV-COND-ALL:[<tid>]::<ctag>::[<condtype>][,,,];
<sid> <date> <time>
M <ctag> COMPLD
"<aid>,<ccm>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"
;
Example 9-30 RTRV-COND-ALL Command and Response
Amp01:ONS15216 EDFA2> RTRV-COND-ALL:Amp01::229::LCRNT1;
Amp01 2002-06-20 14:30:00
M 229 COMPLD
"1,DWDM:MJ,LOS,SA,6-20,14-25-30,,,\"Loss Of Signal\""
"EQPT,EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""
;

Table 9-35 RTRV-COND-ALL Syntax Description

Parameter
aid
conddescr
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
1
EQPT
Description
Possible values are:
Directly affecting the optical signal.
General parameters of the ONS 15216 EDFA2 (not directly
affecting optical signal or power bus).
Detailed text description of the event. The conddescr is 1 to 64
characters of ASCII text. See condtype below.
Cisco ONS 15216 EDFA2 Operations Guide
TL1 Commands and Autonomous Messages
9-41