Provisioning Using TL1
This chapter discusses the provisioning procedures for the Cisco ONS 15216 EDFA2 using TL1
commands in the TL1 shell. See
information using command-line SNMP and proprietary commands in the ASH shell.
The provisioning procedure for the ONS 15216 EDFA2 in the TL1 shell is as follows:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
The following sections describe these steps in detail.
8.1 Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal
Logging in through the RS-232 (EIA/TIA-232) port is required to set the ONS 15216 EDFA2 IP address
before there can be access via the LAN port (see
on page
Connect to the RS-232 (EIA/TIA-232) port on the ONS 15216 EDFA2. See
Step 1
Procedure" section on page 3-15
Open HyperTerminal. (HyperTerminal can be found in the Microsoft Windows Accessories menu.)
Step 2
Step 3
If you see the login window shown in
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal, page 8-1
Set IP Address, page 8-3
Log In via LAN Port Using Telnet (Optional), page 8-3
Set Date and Time, page 8-4
Set Power Bus Mode (Simplex or Duplex), page 8-4
Verify Amplifier Operational Status, page 8-4
Set Gain, page 8-5
Set Alarm Thresholds, page 8-5
Set Password, page 8-10
Add Users, page 8-11
Log Off, page 8-11
Back Up System Configuration, page 8-11
Restore System Configuration, page 8-12
8-3).
Chapter 4, "Provisioning Using ASH and SNMP"
"Log In via LAN Port Using Telnet (Optional)" section
for line connection and HyperTerminal setup instructions.
Example 8-1 on page
Cisco ONS 15216 EDFA2 Operations Guide
C H A P T E R
for provisioning
"LAN Connection
8-2, skip to
Step
4.
8
8-1