User Commands
6.7.1 user entry create Command
Command
user entry create
Syntax Description
user entry create name user_mode
Creates a new user. The parameters required to create a new user are user name, access level, and
password.
The user_mode (access privilege level) is set by entering either read, read_write, or read_write_admin.
See
string of up to 10 characters, where at least 2 are non-alphabetic characters with at least one special character.
Special characters are +, #, and %, as defined in Telcordia GR-831-CORE. See
Example 6-29 user entry create Command
ash:hostname:ONS15216 EDFA2> user entry create jdoe read_write
New Password =
**********
Confirm New Password =
**********
6.7.2 user entry edit Command
Command
user entry edit
Syntax Description
user entry edit username
Edit a user's parameters (name, password, and access level). This command uses the optional parameters
shown at the beginning of
read_write, or read_write_admin). If the password is not to be changed, hit the Enter key when the new
password is requested and confirmed, as shown in
Example 6-30 user entry edit Command (Change Password)
ash:hostname:ONS15216 EDFA2> user entry edit
Options
-new_user_name
-user_mode
Parameters
ash:hostname:ONS15216 EDFA2> user entry edit jsmith
New Password =
******
Confirm New Password =
******
Cisco ONS 15216 EDFA2 Operations Guide
6-26
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Table 6-1 on page 6-1
for the command privileges of each user level. The password must be an ASCII
Example
(string[0..10])
(string[0..16])
user_name
(string[0..10])
6-30. The -user_mode parameter changes the access level (read,
Example
6-31.
new name of user
mode of user
name of user
Chapter 6
ASH Commands
Example
6-29.
78-16033-01