5-32-10. MS-50 Board
4. Remove the four screws as shown in the
figure.
5. Slide the MS-50 board toward the right side
panel, and take off the upper side of MS-50
board from the two step screws.
6. Install the MS-50 board in the reverse order
of steps 2 through 5.
n
The MC sensor harness (connected to the
connector CN16 on the MS-50 board) requires to
thread in the square hole on the center portion of
the MS-50 board.
Adjustment after Replacement
7. Perform the all of servo system electrical
adjustment.
(Refer to Section 3-4.)
5-214
MS-50 board
Square hole
Screw (PWH3 x 8)
Screws (PWH3 x 8)
Screw (PWH3 x 8)
Step screws
CN16
DNW-A100/A50/A45
DNW-A100P/A50P/A45P