Sony DNW-A100 Maintenance Manual page 238

5-9-2. Reel Motor Shaft Slantness Adjustment
Adjustment
6. Loosen Screws
• Spacer for adjusting : 3-717-625-01
Loosen the three screws fixing the reel motor by
one to two turns.
100d to 120d
7. Bend Spacer
Bend the adjustment spacer as shown in the
Spacer
figure.
8. Insert Spacer
Spacer
Insert the adjustment spacer into the square hole
Square hole
on the upper surface of the reel motor plate with
Screw (PSW3 x 10 )
tweezers.
Reel motor shaft
Reel motor plate
9. Tighten Screws
Gradually tighten the three screws loosened in
step 6.
Reel motor
Tightening torque: 68.6 x 10 _2 N . m
Ajustment the Reel Motor Shaft Slantness
{7 kgf . cm}
10. Recheck the Reel Motor Shaft
Slantness
Refer to steps 2 through 5.
5-54
DNW-A100/A50/A45
DNW-A100P/A50P/A45P