Sony DNW-A100 Maintenance Manual page 287

3. RS Table Block Assembly Removal
(1) Remove the RS table block assembly while
pulling out the slide shaft.
(2) Disconnect the flat cable from the connector
on the RM board.
(3) Wipe the grease attached on the two holes,
from which the slide shaft of the RS table
block assembly was pulled out, with cloth.
(4) Wipe the grease attached on the surface of
the slide shaft with cloth.
m
. Be careful the grease on the slide shaft does
not adhere to other parts.
. Be careful not to damage the slide shaft.
4. Harnesses Disconnection
Disconnect the harnesses from the connectors
CN926 and CN927 on the RM board.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
RS table block assembly
RM board
RS Table Block Assembly Removal
CN927
RM board
Harnesses Disconnection
5-15. Brake Solenoid Replacement
Slide shaft
Flat cable
CN926
5-103