Sony DNW-A100 Maintenance Manual page 225

Removal
1. Disconnect the Harnesses
Disconnect the two harnesses from the connectors
of the CTL/FE head assembly.
2. Remove the CTL/FE Head Assembly
Remove the screw, then remove the CTL/FE head
assembly.
n
Be careful not to touch the drum (especially video
heads). Also, take care not to damage the
peripheral tape guides.
3. Remove the CTL Head
(1) Remove the two CTL head securing screws,
then remove the CTL head.
m
. When removing the CTL head, be careful
not to damage the full-erase head.
. Never loosen or remove the screws except
for the CTL head securing screws.
If these screws are loosened or removed,
the zenith of the CTL and the full-erase
head will be out of specification.
(2) Unsolder the connector pins.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
Harness
Remove the CTL/FE Head Assembly
Connector
CTL head
Never loosen or
remove these
screws
5-8. CTL Head Replacement
Harness
Screw (PSW3 x 8)
Full-erase head
CTL/FE retainer
Never loosen or
remove these
screws
Spring washers
CTL head securing
screws (P2 x 3)
Remove the CTL Head
CTL/FE head
assembly
5-41