3. Attach the Fan Motor (Rear)
(1) Attach a new fan motor (rear) so that the
ornamental plate faces to outside and harness
is bottom right side, and tighten the two
screws.
(2) Thread the harness of the fan motor (rear) in
the notch of the insulation sheet.
(3) Connect the harness of the fan motor (rear) to
the connector.
4. Attach the Connector Panel
Attach the connector panel with the six screws.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Connector
Attach the Fan Motor (Rear)
5-13-1. Fan Motor (Rear) Replacement
Harness
Notch of
insulation
sheet
Ornamental plate
Fan motor (rear)
Screws
(BVTT3 x 30)
5-89