Sony DNW-A100 Maintenance Manual page 361

Removal
1. RS Table Block Assembly Removal
Remove the RS table block assembly on the
supply and take-up sides with the reel table
assembly attached. (Refer to procedures 1
through 3 in Section 5-9-1.)
2. Reel Shift Assembly Removal
(1) Remove the three screws.
(2) Raise the reel shift assembly and disconnect
the two harnesses shown in the figure.
3. M Gear Removal
(1) Loosen the two set screws shown in the
figure.
(2) Pull out the M gear from the shaft.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Screw (PWH3 x 8)
Harness
Harness
Reel Shift Assembly Removal
< Bottom view >
Reel shift motor
Set screw
Set screw
M gear
M Gear Removal
5-28. Reel Shift Motor Replacement
Screw (PWH3 x 8)
Screw (PWH3 x 8)
Reel shift assembly
5-177