Sony DNW-A100 Maintenance Manual page 251

Removal
1. Remove the Video Head Cleaner
Assembly
(1) Disconnect the harness from connector
CN851 on the PD-35 board.
(2) Cut the harness clamper.
(3) Remove the harness from the sensor holder.
(4) Remove the screw, shift the video head
cleaner assembly in the direction indicated by
the arrow A, and remove it from the height
determing plate.
n
To remove the securing screws of the capstan
motor, remove the video head cleaner assembly.
2. Remove the Demagnetization Head
Assembly
(1) Turn the knob of the demagnetization head
assembly counterclockwise about seven turns
by finger.
(2) Loosen the hexagonal screw, then remove the
demagnetization head assembly from the
drum assembly.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
PD-35 board
Sensor holder
Remove the Video Head Cleaner Assembly
Hexagonal screw
Knob
Demagnetization
head assembly
Remove the Demagnetization Head Assembly
5-10. Capstan Motor Replacement
CN851
Harness clamper
Harness
Video head
cleaner
assembly
Height
determing
plate
Screw
(PSW3 x 8)
A
5-67