Sony DNW-A100 Maintenance Manual page 337

Removal
1. Reel Table Assembly Removal
(1) Align one of the two notches at the bottom of
the reel table assembly with the groove
position of the RS table block assembly.
(2) Insert the L wrench into the notch at the
bottom of the reel table assembly along the
groove of the RS table block assembly.
(3) Turn the set screw counterclockwise by 1/2 to
one turn, then loosen.
(4) Align the other notch at the bottom of the reel
table assembly with the groove position of
the RS table block assembly.
(5) Loosen the set screw in the same way as in
step (2).
(6) Remove the reel table assembly.
n
A polywasher may be attached together when
the reel table assembly is removed. In this
case, remove the polywasher from the reel
table assembly and return it to the reel motor
shaft. The polywasher is used for reel table
height adjustment.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
S reel table assembly
RS table block
assembly
Set screw
Reel Table Assembly Removal
5-22. Brake Lining Replacement
T reel table assembly
RS table block
assembly
Groove
Notches
Set screw
5-153