Sony DNW-A100 Maintenance Manual page 312

5-19. Gear Box Assembly and Threading Motor Replacement
4. Harness Disconnection
(1) Strech the harness clamper (chassis) shown in
the figure.
(2) Cut off the bundling band.
(3) Disconnect the harness from the connector
CN112 on the DR-315 board.
(4) Disconnect the harness from the connector
CN27 on the MS-50 board.
5. Gear Box Assembly Removal
(1) Cut off the bundling band (A) shown in the
figure.
(2) Remove the two screws and remove the gear
box assembly.
(3) Cut off the bundling band (B) shown in the
figure.
(4) Disconnect the two harnesses from the gear
box assembly.
n
The steps 6 through 9 are not required when
the gear box assembly is replaced.
5-128
Harness clamper (chassis)
CN112
Harness Disconnection
CN920
Bundling
band (B)
Harnesses
Bundling band (A)
Screw
(PWH3 x 8)
Gear Box Assembly Removal
Bundling band CN27
MS-50 board
CCM-15 board
Gear box
assembly
Screw
(PWH3 x 8)
DNW-A100/A50/A45
DNW-A100P/A50P/A45P