5-9-4. Reel Table Height Adjustment
5. Place the Reel Shift Plate Assembly in
the S Cassette Position
Rotate the drive gear clockwise as far as it will
go.
6. Check the Supply and Take-up Reel
Table Height
Perform in the same way as in steps 3 and 4.
If the specification is not satisfied, perform steps
7 and later.
If the specifications are satisfied in both the L and
S cassette positions, perform steps 9 and later.
5-58
< S cassette position >
S reel table
Cassette
reference
plate (L)
Drive gear
Flange
Reel table
*
The * marked portion of the gauge slide over
Spec.:
the flange of the reel table.
The ** marked portion of the gauge does not
slide over.
T reel table
Reel table height
check gauge
Cassette reference
plate (L)
**
DNW-A100/A50/A45
DNW-A100P/A50P/A45P