21. Put the Unit into the Unthreading End
State.
22. S Tension Regulator Assembly
Installation
(1) Clean the mounting surfaces of the S tension
regulator assembly and chassis in the three
portions.
(2) Set the S tension regulator assembly and
tighten with the three screws.
(3) Connect the harness to the connector CN1 on
the TC-96 board.
(4) Put the harness in the harness clamper.
(5) Confirm that the harness does not protrude
into the mounting surface (
figure) of the cassette compartment.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Cleaning
portion in the
Screw
(PWH3 x 8)
Harness clamper
Cleaning
Mounting surface of cassette compartment
5-20. Threading Ring and Ring Roller Replacement
Screw (PWH3 x 8)
S tension regulator assembly
Screw
(PWH3 x 8)
CN1
S Tension Regulator Assembly Installation
Cleaning
TC-96 board
Cleaning
5-143