Sony DNW-A100 Maintenance Manual page 351

3. Cleaning Solenoid Removal
(1) Remove the two screws and washers, then
remove the shield case containing a solenoid.
(2) Take out the solenoid from the shield case.
(3) Remove the CL washer from the iron core of
the solenoid.
Installation
4. Cleaning Solenoid Installation
(1) Pass the CL washer through the iron core of a
new solenoid.
(2) Align the solenoid with the hole of the
cleaner base while putting the groove of the
iron core between the pins of the cleaner
lever and temporarily tighten the two screws.
(3) Put the shield case in the direction shown in
the figure and insert it between the cleaner
base and solenoid.
(4) Adjust the solenoid position so that the
clearance between the cleaner lever and
cleaner base is 1 mm with the iron core
pushed in the direction of the arrow and
tighten the two screws.
Tightening torque: 19.6 x 10
{2.0 kgf . cm}
(5) Slightly apply locking compound to the
screws.
(6) Put the harness in the harness clamper.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Screws (PS2 x 4)
. Cautions during installation
Step 4-(2)
_2 N . m
Step 4-(4)
Cleaner base
Washer
Washer
Iron core Pins
Cleaner lever
Solenoid
Screws (PS2 x 4)
Cleaner lever
Cleaning Solenoid Removal/Installation
5-26. Cleaning Solenoid Replacement
Shield case
Cleaning solenoid
CL washer
Cleaner lever
Solenoid
Cleaner base
Harness
clamper
1 mm
5-167