Sony DNW-A100 Maintenance Manual page 298

5-17. T Tention Arm Replacement
3. Yoke Plate Removal
Remove the screw, then remove the yoke plate
from the T tension arm.
Installation
4. Yoke Plate Installation
(1) Put the yoke plate in the direction shown in
the figure and tighten the screw.
(2) Slightly apply locking compound to the yoke
plate.
5. T Tension Arm Installation
(1) Clean the shaft.
(2) Insert the two bearings into the T tension
arm.
(3) Put the two springs on the T tension arm as
shown in the figure.
(4) Pass the T tension arm through the shaft
while putting DME on the TR-79 board in the
T tension arm.
(5) Fix the T tension arm using a new stop
washer.
5-114
Screw (B2 x 5)
Apply locking
compound
Paint side (white)
Yoke Plate Removal/Installation
Stop washer
Bearings
T Tension Arm Installation
T tension arm
Yoke plate
T tension arm
Springs
Shaft (cleaning)
DME
TR-79 board
DNW-A100/A50/A45
DNW-A100P/A50P/A45P