Sony DNW-A100 Maintenance Manual page 277

4. Replace the Fan Motor (HDD)
(1) Disconnect the harness from the connector
shown in the figure.
(2) Remove the two screws and remove the fan
motor (HDD).
(3) Remove the two screws and remove the fan
motor (HDD) from the fan motor bracket.
(4) Attach the fan motor (HDD) to the fan motor
bracket so that the ornamental plate faces to
the opposite side of the fan motor bracket and
the harness is top left side, and tighten the
two screws.
n
The type of this fan motor (HDD) is
"109P0612H7D01".
Take care to use the correct type since the
sharpes of the fan motor (HDD) and the fan
motor (MD) are the same.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
5-13-3. Fan Motor (HDD) and Fan Motor (MD) Replacement
Screws
(B3 x 6)
Connector
Replace the Fan Motor (HDD)
Fan motor
Harness
Ornamental plate
(Type:109P0612H7D01)
Screws
(B3 x 20)
Replace the Fan Motor (HDD)
Fan motor (HDD)
Fan motor bracket
5-93