Sony DNW-A100 Maintenance Manual page 234

5-9-1. Replacement Procedure of the Reel Motor Assembly
9. Connect the Flat Cable
(1) Clean the inserting portion of the flat cable
using a dry cleaning cloth.
(2) Connect the flat cable disconnected in step 3
to the connector on the RM board, then lock.
m
. Connect the flat cable with its conductor
plating part (printing surface) up.
. Be careful not to bend the flat cable when
connecting it.
10. Insert the Slide Shaft
Pass the slide shaft through the hole of the RS
table block assembly.
11. Attach the RS Table Block Assembly
(1) Put the slide shaft on the shaft holder while
inserting the portion A shown in the figure of
the RS table block assembly into the slide
table.
(2) Attach the slide shaft support with the screw.
12. Apply the Grease to the Slide Shaft
(1) Slightly apply grease to the slide shaft and it
to the whole slide shaft.
n
Be careful that the grease does not adhere to
other parts.
(2) Confirm that the RS table block assembly
smoothly moves when it is shifted to S
cassette and L cassette positions.
13. Attach the Crank Arm
(1) Clean the shaft of the crank arm (A), then
apply one a drop of oil on it.
(2) Confirm that the RS table block assembly is
in the middle between S and L cassette
positions.
(3) Attach apply one the crank arm (B) to the
shaft of the crank arm (A) with the E ring.
5-50
Portion A
RM
board
Slide table
Flat cable
Attach the Slide Shaft
E ring
Apply oil
Crank arm (B)
after cleaning
Crank arm (A)
RS table block assembly
Slide shaft
Attach the Crank Arm
Slide shaft
RS table block assembly
Screw (PWH3 x 8)
Slide shaft support
Shaft holder
Cleaning
Grease applying
DNW-A100/A50/A45
DNW-A100P/A50P/A45P