Setting Ip Addresses; Preparations For Work - Omron V780 Series User Manual

5-2

Setting IP Addresses

5-2-1

Preparations for Work

1
Network Configuration
The network configuration that is described in this manual is shown in the following figure.
Connect the Reader/Writer and the computer with an Ethernet Cable.
Reader/Writer
2
Set the IP address on the computer.
Set the IP addresses on the computer.
The default IP addresses of the Reader/Writer are given in the following table. Use these
addresses to set the IP address on the computer.
This example changes the last part of the IP address to a value other than 200 (i.e., to 1 to 199
or 201 to 254). Values of 0 and 255 cannot be used.
• Default IP Address Settings of the Reader/Writer
IP address
Subnet mask
Default gateway
Setting the IP Address on the Computer with Windows 7 or Windows 10
1
Open the Control Panel, and select Network and Internet and then Network and Sharing
Center.
2
Select Change adapter settings and then right-click Local Area Connection.
3
Right-click Local Area Connection and select Properties.
4
Select Internet Protocol Version 4 (TCP/IPv4) and then click the Properties Button.
5
Select the Use the following IP address Option, make the following settings, and then click the
OK Button.
Change the last part of the IP address to a value other than 200 (i.e., to 1 to 199 or 201 to 254).
Values of 0 and 255 cannot be used.
6
Click the OK Button to close the Internet Protocol Version 4 (TCP/IPv4) Properties Dialog Box.
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
Switching Hub
Power Supply Cable
Ethernet Cable
Setting item
192.168.1.200 (fixed setting)
255.255.255.0 (fixed setting)
192.168.1.254 (fixed setting)
5 Preparations for Communications
Computer
Ethernet Cable
Default setting
5
5 - 3