Omron V780 Series User Manual page 302

8 Browser Interface
Advanced Settings 2
Click the RF communication settings Button and then click the Advanced settings 2 Tab.
A tab page to set the advanced parameters for communications with RF Tags will be displayed. You can
edit the settings.
Item name
RSSI filter
High threshold
Low threshold
RF Tag select filter
Memory address
Verification data
For information on the advanced settings, refer to 6-4-3 RF Communications Conditions: Advanced
Settings on page 6-25.
Precautions for Correct Use
• Click the Set Button. The settings will be applied immediately.
• If you change the settings while the Reader/Writer is performing RF Tag communications,
noise measurement, or other processing, an error message will be displayed. Change the
settings when the Reader/Writer is in idle state.
8 - 12
Click this button to set the
displayed values.
Select whether or not to use filtering for reception levels.
Setting range: Enable or Disable
Enter the high threshold for the reception level.
Setting range: 0 or −70 to −10
Enter the low threshold for the reception level.
Setting range: 0 or −70 to −10
Select whether or not to use filtering for RF Tag data verification.
Enter the memory address to use for verification in the RF Tags.
Setting range: 1000 to 17FF hex (UII (EPC) area)
2000 to 27FF hex (TID area)
3000 to 37FF hex (user area)
Enter the data to verify with the data in the RF Tags.
Setting range: 16 hexadecimal words max.
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
Description Default
Disable
---
---
Disable
---
---