Omron V780 Series User Manual page 300

8 Browser Interface
Advanced Settings
Click the RF communication settings Button and then click the Advanced settings Tab.
A tab page to set the advanced parameters for communications with RF Tags will be displayed. You can
edit the settings.
Item name
Tx power (Read)
and Tx power
(Write)
*1
Channel
Gen2 session
Access password
Transmission time
Continuous
time
Stop time
*1. The channel used can only be specified in models V780-HMD68-ETN-IN/-EU/-RU. The channel cannot be
specified in the other models.
*2. You cannot specify either one of the stop time and continuous transmission time as 0 in the model
V780-HMD68-ETN-JP. This cannot be set to 0 in models other than V780-HMD68-ETN-JP. The default is 10.
*3. The default settings depends on the each model number. For details, refer to Transmission Time on page 6-27.
For information on the advanced settings, refer to 6-4-3 RF Communications Conditions: Advanced
Settings on page 6-25.
8 - 10
Click this button to set the
displayed values.
Enter the reading transmission power and the writing transmission power
separately for the antenna output.
Setting range: 15 to 27
Select the frequency channel to use.
For details on the settings, refer to Channel on page 6-25.
Select the value for the Gen2 session flag.
Setting range: S0, S1, S2, or S3
Enter the RF communications access password in eight hexadecimal digits. 00000000
Enter the time to output radio waves continuously and the stop time when
the Reader/Writer communicates with RF Tags.
Enter the maximum time to continuously output radio waves during commu-
nications command execution.
Setting range: 0 or 400 to 10000 [ms]
*If you set 0, the time will be infinite.
Enter the time to pause output during communications command execution.
Setting range: 0 or 10 to 1000 [ms]
*If you set 0, the time will be 0.
Description
*2
*1
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
Default
27
Auto channel
S0
―
*3
*3