Omron V780 Series User Manual page 253

GET TRANSMISSION TIME
 Function
This command is used to check the transmission times that are set in the Reader/Writer.
 Command Format
Byte-0 Byte-1
Transaction identi-
fier
X X
Parameter
Register address
Word count
 Response Formats
• Normal Response
Byte-0 Byte-1
Transaction identi-
fier
X X
Byte-9 Byte-10
Stop time
2 bytes
Parameter
Field length
Byte count
*1.
Stop time
V780-HMD68-E
TN-JP
V780-HMD68-E
TN-KR/-SG/-TW
/-US/-MX
V780-HMD68-E
TN-CN
V780-HMD68-E
TN-IN/-EU/-RU
Continuous
transmission time
V780-HMD68-E
TN-JP
Models other
than
V780-HMD68-E
TN-JP
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
Byte-2 Byte-3 Byte-4
Protocol identifier Field length
0000 hex 0006 hex
The register address (C700 hex) that specifies reading the trans-
mission time settings
Always 0002 hex.
Byte-2 Byte-3 Byte-4 Byte-5
Protocol identifier Field length
0000 hex 0007 hex
Byte-11 Byte-12
Reserved
Always 0000 hex.
Always 0007 hex.
The number of bytes in the transmission times to read (04 hex)
Gives the time that is set to stop the output during RF communications command execu-
tion in 4-digit hexadecimal.
0000 hex, 000A hex to 03E8 hex
(0000 hex is ignored, or 10 to 1,000) [ms]
000A hex to 03E8 hex
(10 to 1,000) [ms]
000A hex to 03E8 hex
(10 to 1,000) [ms]
0064 hex to 03E8 hex
(100 to 1,000) [ms]
Gives the maximum time to continuously output radio waves during the execution of the
communications command in 4-digit hexadecimal.
0000 hex, 0190 hex to 2710 hex
(0000 hex is infinite, or 400 to 10,000) [ms]
Always 0000 hex.
7 Modbus/TCP Communications
Byte-5 Byte-6 Byte-7
Unit Function
identifier code
FF hex 03 hex
Description
Byte-6 Byte-7
Unit Function
identifier code
FF hex 03 hex
Description
Byte-8 Byte-9 Byte-10 Byte-11
Register address Word count
C700 hex 0002 hex
Byte-8
Byte
count
04 hex
Default setting
0000 hex
000A hex
000A hex
0064 hex
0000 hex
---
7 - 101
7