Omron V780 Series User Manual page 304

8 Browser Interface
Multi-Reader/Writer Setting
Click the Device settings Button and then click the Multi-Reader/Writer setting Tab.
A tab page to customize the multi-reader/writer on the Reader/Writer will be displayed.
The slave reader/writer (V780-HMD68-ETN--S) can not change the multi reader/writer configuration
setting.
Click Update Button to re-get the status of each Slave Reader/
Writer stored in the Master Reader/Writer.
* The status of the Slave Reader/Writer stored in the Master
Reader/Writer varies under the following conditions.
1. Multi Reader Writer Mode is during normal or abnormal startup
2. From Master Reader/Writer to Slave Reader/Writer during
communications failed or success.
Item name
Multi-Reader/Writer Mode Select whether or not to use the Multi-Reader/Writer mode.
Mode Selection
Slave Reader/Writer Sta-
tus
IP address
Tx power(Read)
Tx power(Write)
8 - 14
Description
Setting range: Enabled or Disabled
This selects the mode if the Multi-Reader/Writer mode is
enabled.
Setting Range: Communications Range Extension Mode
This gives the status of each slave Reader/Writer.
Connected: (Green)
Not connected: (Red)
Communications failed: (Red)
Not registered: (Gray)
This gives the IP addresses assigned to each Reader/Writer.
This gives the value of the read transmission power, and a
level bar, for each slave Reader/Writer.
This gives the value of the write transmission power, and a
level bar, for each slave Reader/Writer.
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
Click this button to set the
displayed values.
Default
Disable