Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
6. Using a #2 Phillips screwdriver, attach the rack seal plate to the holes with the cage nuts with the M5
screws.
7. From the rear of the rack, reinstall the rear fans on the bottom Storage Enclosure Basic.
a. From the rear of the chassis, place the bottom of the fan on the rubber bumpers on the chassis.
Warning: Do not place fingers anywhere near the fan blades while powered on.
b. Tilt the top of the fan inward until the top of the fan is seated into the chassis.
c. Repeat the previous steps to install the remaining rear fans.
Figure 6-82. Installing the rear fans
8. From ActiveScale™ X100 SM, power on the system.
81
Advertisement
Table of Contents
