ActiveScale™ X100 Installation Guide
The check mark indicates successful completion of the pre-login configuration.
Figure 5-67. Pre-Login: check mark
16. (Optional) Disconnect your laptop from the System Node's eth2 port.
You can do post-login configuration through your physical connection to the eth2 port or remotely
over Public Network 1 if you made a note of the new IP address of System Node 1. If you did not
make note of this IP address, do not disconnect; wait to click Proceed to Login.
5.3.5 Run the post-login configuration wizard (multi-site version)
The post-login wizard guides you through the remaining configurable items. These steps should be
executed by the primary system administrator only, at the primary site.
Note: Western Digital Support must confirm that BMC IPMI IP addresses are
reachable (pingable) before starting the post login configuration phase. If any
64