Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
8. Click each tab on the Site Review page to review your IP assignments.
Warning: It is crucial that you correct any errors on this page. To make
corrections, click Back and edit the settings.
Warning: Once you navigate forwards to the Apply Progress page, you can no
longer change Storage Network 1 and Storage Network 2 settings.
a. Click the Public tab.
The wizard displays the IP addresses for the public network(s). Check each IP assignment to
make sure it is correct.
Note: Write down the public IP address and subnet information, because you
need this to log into the system for post-login configuration.
b. Click the Management tab.
The wizard displays the IP addresses for System Network 1 and System Network 2. Check each
IP assignment to make sure it's correct.
c. Click the Storage tab.
The wizard displays the IP addresses for Storage Network 1 and Storage Network 2. Check
each IP assignment to make sure it's correct. Verify that the IP addresses in columns IP Address
1 and IP Address 2 do not conflict.
Figure 5-33. Pre-Login > Site Review > Storage
33
Advertisement
Table of Contents
