Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
Important: The system must be completely powered on at this point.
Warning: The 10GbE cables from SFP+ ports 1 and 3 on each System Node
must not be connected to your network(s) at this point, to avoid possible IP
conflicts.
Tip: All fields in the pre-login configuration wizard are mandatory unless
otherwise noted.
Warning: Do not use your web browser's Back or Forward buttons to navigate
through the wizard.
1. Configure a connection to the default link local IP address of the eth2 network interface on any of the
System Nodes.
a. Connect an RJ45 (CAT6) cable from your laptop's Ethernet port to the eth2 port on one of the
System Nodes.
The figure below illustrates the location of the System Nodes.
Figure 5-26. Location of System Nodes: label "4"
29
Advertisement
Table of Contents
