Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
e. Extend the outer rail forward and insert the pegs into the front vertical rail.
Figure 9-4. Rail attaching to front vertical rail
f. Extend the inner rail to its full length.
g. Remove the inner rail by sliding the white clip with a rounded edge forward.
Note: Be cautious leaving the outer rails extending out of the rack. Consider
pushing the outer rails back until you are ready to install the node.
h. Repeat the previous steps to attach the other rail to the rack.
2. Attach the inner rails to the node.
a. Align the holes in the inner rail with the pegs on the side of the node.
b. Slide the rail forward to lock it in place.
Figure 9-5. Locking the inner rail to the node
c. Secure the inner rail to the node using one of the screws.
Repeat these steps to attach the second rail.
115
Advertisement
Table of Contents
