Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
d. Click the IPMI tab.
The wizard displays the IPMI IP addresses for the system. Check each IP assignment to make sure
it's correct. Verify that the IPMI IP addresses do not conflict.
8. On each configuration wizard, click Next.
The Inter Site Connectivity page appears on each configuration wizard. Each wizard waits
indefinitely for connectivity with the other two sites. When the wizard establishes connectivity, it
enables the Next button on the page.
Tip: At this point, no further human interaction at the secondary sites is
necessary unless the wizard finds any errors. If errors are found, click Back.
Figure 5-60. Pre-Login > Inter Site Connectivity (primary site)
59
Advertisement
Table of Contents
