Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
d. Click the IPMI tab.
The wizard displays the IPMI IP addresses for the system. Check each IP assignment to make sure
it's correct. Verify that the IPMI IP addresses do not conflict.
9. Click Apply.
The Apply Configuration page appears, with an estimate of the time remaining. Estimated
completion times are based on your system's configuration.
Warning: Do not click your web browser's Back button while the Apply
Progress page is displayed.
Figure 5-34. Pre-Login > Apply Configuration
10. Wait until the Pre-Configuration icon has a check mark and the Post-Login Configuration image is
highlighted, as shown in the image below.
The check mark indicates successful completion of the pre-login configuration.
Figure 5-35. Pre-login checkmark
11. (Optional) Disconnect your laptop from the System Node's eth2 port.
You can do post-login configuration through your physical connection to the eth2 port or remotely
over Public Network 1 if you made a note of the new IP address of System Node 1. If you did not
make note of this IP address, do not disconnect; wait to click Proceed.
5.2.3 Connect the system to your networks
Important: System Expansion Nodes are installed after initial system bringup.
For more information, refer to page
on page 110.
Connect your fiber optic cables to each System Node's SFP+ transceivers as follows.
101Installing System Expansion Node kits
34
Advertisement
Table of Contents
