Table of Contents
Advertisement
ActiveScale™ X100 Installation Guide
• From site 1 to site 2: The
• From site 1 to site 3: The
• From site 2 to site 1: The
• From site 2 to site 3: The
• From site 3 to site 2: The
• From site 3 to site 1: The
1. Configure a computer with an IP address in the network's range.
2. Verify the data paths and latency using ping.
Confirm that are no lost packets and that the latency is consistent and as expected.
Warning: Do not assume that if site A can reach site B, that means site B can
reach site A, or that the bandwidth and latency values in both directions are the
same.
Sample ping command from site A to site B:
ping -c 25 -t network_interface site_B_gateway_IP_address
Sample expected output:
64 bytes from 192.168.1.254: icmp_req=1 ttl=64 time=0.274 ms
64 bytes from 192.168.1.254: icmp_req=2 ttl=64 time=0.194 ms
64 bytes from 192.168.1.254: icmp_req=3 ttl=64 time=0.255 ms
64 bytes from 192.168.1.254: icmp_req=4 ttl=64 time=0.208 ms
5.3.2.5 Create uplinks
Connect transceivers to specific System Interconnect uplink ports, depending on your chosen uplink mode,
and connect cables from these transceivers to your corresponding network, at each site. For uplink ports
and connections, refer to the table below.
network be connected to the
.110
network be connected to the
.110
network be connected to the
.120
network be connected to the
.120
network be connected to the
.130
network be connected to the
.130
50
network.
.120
network.
.130
network.
.110
network.
.130
network.
.120
network.
.110
Advertisement
Table of Contents
