Table of Contents
Advertisement
Installation Guide
The following section provides specific information necessary to install, service, and remove the Ultrastar
Serv60+8 . The installation of the Ultrastar Serv60+8 requires two people and a space of 1524mm / 60in.
in front of the installation space. The servicing of the enclosure requires one person and a minimum of
1219.2mm / 48in. of space in front of the installation space. The removal of the enclosure requires two
people, 1371mm / 54in. of space in front of the installation space, and 24in. on either side of the enclosure
for two people to remove the enclosure.
Warning: The handles on the front of the chassis are not intended to be used to support the
weight of the Ultrastar Serv60+8 . Lifting the unit by the chassis handles or trying to support
the unit on the handles can cause them to fail. This can cause serious damage to the unit or
serious bodily harm to those handling the unit. Always team lift the chassis by gripping the
underside of the unit, and never try to lift a chassis that is filled with drives.
Figure 6: Installation, Servicing, and Removal
Attention: Do not install or remove the enclosure while it is populated with drives. The fully
populated enclosure exceeds the amount of weight that a team of two should lift.
1.7.1 Compatible Rack Hardware Configuration
The following table(s) list the approved rack hardware configurations for the Ultrastar Serv60+8 :
Table 7: Compatible Hardware Configuration 1
Parameter
Vendor CRENLO/EMCOR
Part
Number EMCOR
Number
Rack
PDU (Vertical)
Server Technology
AS-160099-03
412-0761-11_STV-4501
(Drawing
412-0761-20_STV-4502
526121 Rev 5)
412-0761-23_STV-4503
1.7 Ultrastar Serv60+8 Rack Requirements
PDU Mounting
Bracket
Server Technology
KIT-MBVPT-1B
(one kit per PDU)
1. Overview
Additional Mounting
Bracket Hardware
Various
4 x M6 x 16 Hex
Cap Screws
8 x M6 Fender
Washers
8
Advertisement
Table of Contents
