Siemens Sinumerik 840D sl Function Manual page 729

10/15
Response
Remedy
Program r
continuation
27299
Parameter
Explanation
Response
Remedy
Program r
continuation
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
The following displays are possible for communication type (%1):
-- F modules
-- SPL
One of the following F components (%2) can be involved:
-- PROFIsafe address or the name of the F module involved (for com-
munication type = F module)
-- "--" (for communication type = SPL)
One of the following error causes is possible (see fault ID %3):
-- SF: Asynchronous fault state (StateFault)
-- SP: The SPL input/output data are not updated (SPL I/O--communi-
cation)
The specified error IDs, depending on the error profile, can also be
displayed in a combination.
One of the following components (%4) can be involved:
-- NCK
-- PLC
NC start disable in this channel
Alarm display
Mode group not ready
Channel not ready
NC stop for alarm
Interface signals are set
A STOP D/E is initiated (this can be set using MD10097
$MN_SAFE_SPL_STOP_MODE) on all axes with safety functionality.
Stop of the PROFIsafe driver involved. Stopped PROFIsafe driver of
type F--DI or F--DIO F modules -- output fail--safe values (0) towards
the SPL as F net data.
Power--down/power--up the control (power on). If this fault occurs
again, contact the service department.
Switch--off – switch--on the control
PROFIsafe: Diagnostics %1 %2 %3 %4
%1 error ID 1
%2 error ID 2
%3 error ID 3
%4 error ID 4
Errors in the PROFIsafe configuration.
The component (PLC or NCK), which detected the error, is specified in
the alarm text.
Alarm display
With the error text, open a support request at:
http://www.siemens.com/automation/support--request
Switch--off – switch--on the control
10.2NCK safety alarms for Sinumerik 840D sl
Diagnostics
10-729