Siemens Sinumerik 840D sl Function Manual page 387

10/15
36903
MD number
Default value: 0H
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
corresponds with ...
Additional references
36904
MD number
Default value: 0H
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
$MA_SAFE_CAM_ENABLE
Function enable safe cam track
Min. input limit: 0H
Protection level: 7/2
30 safe cams can be enabled for one axis/spindle for the "safe cam track" function using
this machine data.
The enable signals may only be issued if the cam enable is not used in MD36901
$MA_SAFE_FUNCTION_ENABLE.
The cam synchronization is automatically activated if the "safe cam track" function is
enabled.
Bit 0: enable safe cam track, cam 1
Bit 1: enable safe cam track, cam 2
Bit 2: enable safe cam track, cam 3
Bit 3: enable safe cam track, cam 4
Bit 4: enable safe cam track, cam 5
Bit 5: enable safe cam track, cam 6
Bit 6: enable safe cam track, cam 7
Bit 7: enable safe cam track, cam 8
Bit 8: enable safe cam track, cam 9
Bit 9: enable safe cam track, cam 10
Bit 10: enable safe cam track, cam 11
Bit 11: enable safe cam track, cam 12
Bit 12: enable safe cam track, cam 13
Bit 13: enable safe cam track, cam 14
Bit 14: enable safe cam track, cam 15
Bit 15: enable safe cam track, cam 16
Bit 16: enable safe cam track, cam 17
Bit 17: enable safe cam track, cam 18
Bit 18: enable safe cam track, cam 19
Bit 19: enable safe cam track, cam 20
Bit 20: enable safe cam track, cam 21
Bit 21: enable safe cam track, cam 22
Bit 22: enable safe cam track, cam 23
Bit 23: enable safe cam track, cam 24
Bit 24: enable safe cam track, cam 25
Bit 25: enable safe cam track, cam 26
Bit 26: enable safe cam track, cam 27
Bit 27: enable safe cam track, cam 28
Bit 28: enable safe cam track, cam 29
Bit 29: enable safe cam track, cam 30
MD36901 $MA_SAFE_FUNCTION_ENABLE
/FBSIsl/ see Chapter 6.8 "Safe software cams, safe cam track (SN)
$MA_SAFE_ADD_FUNCTION_MASK
Enables additional functions for Safety Integrated
Min. input limit: 0H
Protection level: 7/2
Bit 0:
On the NCK side, for STOP B and C, braking is not initiated by entering "Speed setpoint 0".
Braking is realized on the drive side, based on the OFF3 ramp.
8.1 Machine data for SINUMERIK 840D sl
Max. input limit: 3FFF FFFFH
Max. input limit: 1H
Data Description
Unit: - -
Unit: - -
8-387