Removing The Fan Unit; Installing The Small Faceplate On The Network Interface Card - Avaya S8500 Manual

Installing the network interface card
Figure 5: Locating the server cover's captive screws
Figure notes
1 Server cover's captive screws

Removing the fan unit

1
Locate the slot labeled PCI-2 on the left hand side of the back of the server under the fan unit.
2
Remove the two screws holding the fan unit. There is no need to unplug the fan unit.
3
Set the fan on the adapter-support bracket to the right.
Installing the small faceplate on the network
interface card
One type of NIC comes from the factory with a standard faceplate. You must remove this faceplate and
replace it with a smaller one that fits the space. See
If you have a NIC that does not require a small faceplate, proceed to
on page 43.
1
Using a #1 Phillips screwdriver, unscrew the two screws holding the larger faceplate.
2
Remove the faceplate from the NIC.
3
Position the small faceplate over the Ethernet ports. The faceplate must align with the screw holes
on the circuit board.
4
Screw the small faceplate onto the circuit board using the two screws removed in step 1.
42
d is
c
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
h3mscaps LAO 070103
Figure , , on page 43.
Inserting the network interface card
1
December 2003