Connecting The P333T-Pwr Switch - Avaya S8500 Manual

The P333T-PWR switch has 24, 10/100 Base-T ports, each of which can supply up to 16.5 watts using the
internal power supply and operates on a 100–240 volts AC, 5.3 amperes, 50/60 hertz power source with
the option of using the 44~57 volts DC, 15 amperes to boost the InLine power.
The P333T-PWR switch can be placed in a wiring closet or on a flat, stable surface like a desk. Screws
are provided for mounting in a standard 19-inch (48-centimeter) rack.

Connecting the P333T-PWR switch

Powering up—AC input
1
Insert the power cord into the power connector (BUPS or AC Power Supply) on the rear of the
unit. See
Figure 109: Connectors on the P333T-PWR switch
Figure notes
1 BUPS connector
2
Insert the other end of the power cord into a nonswitched electrical outlet or the connector on the
BUPS.
The unit powers up and performs a self-test procedure. The LEDs flash at regular intervals after
the self-test procedure is completed successfully.
Powering up—DC input (optional)
The P333T-PWR switch can operate on the AC input only. However, you may wish to use the optional
DC input for the following:
•
Backup for the power over Ethernet ports
•
To provide more than 200 watts for the power over Ethernet ports
Connecting the cables
Connect IP telephones, PCs, servers, routers, workstations, and hubs.
1
Connect the Ethernet connection cable (not supplied) to a 10/100 megabits per second port on the
front panel of the Avaya P333T-PWR switch.
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
December 2003
Figure 109, Connectors on the P333T-PWR switch,
1
BUPS
INPUT
NOTE:
Please see the P333T-PWR switch User's Guide for more information.
NOTE:
Use standard RJ45 connections and a CAT5 cable for 100 megabits per second operation.
Installing and wiring telephone power supplies
on page 281.
2
INPUT
Vin 44-57V Amax 15A
2 AC connector
scdlp333 KLC 082002
281