Avaya S8500 Manual page 225

Reusing a TN2312AP/BP circuit pack
1
Plug the circuit pack into the appropriate slot in the media gateway or if already plugged in, reseat
it (unplug and plug in).
2
While the letters I P are flashing on the LED display (5 seconds), press the recessed pushbutton on
the faceplate.
3
The circuit pack is now ready for a new static IP address.
Administering the static IP address
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type command
4
Type arp -d 192.11.13.6
responds with one of the following:
•
•
5
Type
telnet 192.11.13.6
Prompt = [IPSI]:
6
Type ipsilogin
7
Log in as craft.
Prompt = [IPADMIN]:
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
December 2003
CAUTION:
If reusing TN2312AP or TN2312BP circuit packs that have previously had a static address
programmed, you must erase the existing IP address before programming another one.
Failure to do this may result in serious network problems for the customer. Use the
following procedure to erase an existing IP address assignment:
NOTE:
Make sure you have the password before proceeding.
and press Enter to open a MS-DOS Command Line window.
and press
The command line prompt when the cache has been cleared.
The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
and press Enter to open the Telnet window and connect to the IPSI
NOTE:
While connected to the IPSI, type
two or three letter abbreviations.
and press Enter. (abbreviated command = il)
NOTE:
The craft login used on the IPSI has a different password than the craft login used on the
media servers.
Connecting to the IP server interfaces
Enter to clear the ARP cache in the laptop. This command
help or ? to obtain online help. Most commands have
225