Mounting Two To Five G650 Media Gateways; Installing The Tn2312Bp Ipsi Adapter - Avaya S8500 Manual

Mounting two to five G650 Media Gateways

When mounting more than one G650 Media Gateway in a rack, put:
1
A in the bottom of the rack
1
B directly above A
2
C directly above B
3
D directly above C
4
E directly above D
EMI gaskets provide Electro Magnetic Interference (EMI) to or from the TDM cable with the outside
environment. You must install the EMI gaskets before putting cabinets B, C, D, or E in the rack.
To install the EMI gaskets:
1
Peel the paper backing from the gasket
2
Locate the unpainted outlined area on top of the G650 Media Gateway
3
With the gasket opening facing the rear of the rack, place the gasket on the:
a
b
After you put the last G650 in the rack:
1
Cable the rack (see
2
Install the TN2312BP IPSI adapter (proceed to
112).

Installing the TN2312BP IPSI adapter

Install the TN2312BP IPSI adapter on the connector panel in position 1 for carrier A. If you are using
duplicated IPSIs, connect another IPSI adapter in position 1 for carrier B. Connect the CAT 5 ethernet
cable to the adapter to connect the G650 to the ethernet.
the adapter.
If you want to use the external alarm function, attach an 9-pin external alarm cable to the TN2312BP IPSI
adapter. For the unterminated end, see the Job Aid entitled
Charts).
112
Right top for G650 A and C
Left top for G650 B and D
Cabling the G650 Media Gateways
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
on page 121).

Installing the TN2312BP IPSI adapter

Figure 21, G650 IPSI adapter,
Connector and Cable Diagrams (Pinout
on page
on page 113 shows
December 2003