Telneting To Media Server; Enabling Alarms To Inads Via Modem; Enabling Alarms To Inads Via Snmp - Avaya S8500 Manual

b
c
4
Select Save ACP translations prior to backup to save translations to the CF.
5
Click Start Backup.
6
Click Backup Status to view the status of the backup.

Telneting to media server

1
Click Start > Run to open the Run dialog box
2
Type telnet 192.11.13.6
3
Log in as

Enabling alarms to INADS via modem

1
Type
almenable -d b
2
Type almenable

Enabling alarms to INADS via SNMP

1
Type almsnmpconf -d ipaddress -c communityname
trap receiver address for the SSG device and communityname is the community string name
required by the SSG device.
2
Type
almsnmpconf
Verify that the correct information was entered.
3
At the prompt, type
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
December 2003
Select either Local PC Card and Format PC Card or Format PC Card (the second
such selection further down the screen).
Use Local PC Card and Format PC Card To format the PC card and backup the data
onto it.
Use Format PC Card to format new cards or to overwrite a card in use.
Click Format.
You will be notified when the format is completed (approximately 10 seconds).
NOTE:
Customer's may want to back up using another method.
NOTE:
Clicking on Start Backup without a CF in the reader results in an error. To continue with
the backup, unplug the CF reader, insert the formatted CF in the bottom slot, and plug the
reader back into the USB port.
and press Enter.
or (if business partner).
craft dadmin
and press Enter
and press Enter to verify that the alarms are enable
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device, see (Avaya personnel only): http://135.8.11.4/team-sra/.
and press Enter.
almenable -s y
Completing the installation administration
.
and press Enter, where ipaddress is the
and press Enter.
d.
289