Confirming Original Ethernet Configuration; Configuring The Nic - Avaya S8500 Manual

Installing the network interface card

Confirming original Ethernet configuration

After the Media Server is back in service, check the original Ethernet configuration settings:
1
Go to the Configure Server Web page.
2
Confirm that the server's Ethernet configuration settings are the same as before.

Configuring the NIC

1
Under Server, click Configure Server
2
Click Continue through the review notices until you get to the xxx page.
3
Select Configure Individual Services and click Continue.
4
Select Set Identities and click Continue.
5
The following Ethernet ports are listed:
•
•
•
•
6
Using the drop-down menu, set the
a dedicated, separate Ethernet port.
7
Click Continue.
8
Fill in the following information for Ethernet 2:
•
•
•
•
9
Select "VLAN 802.1q priority tagging is enabled" if true.
10
Click Change. The status of the configuration update appears in the window.
When the update completes, the following message appears:
ethernet interfaces
46
Control Network A: [default: Ethernet 0]
Services Port: [default: Ethernet 1]
Corporate LAN: [default: Ethernet 0]
Unused
IP address
Gateway
Subnet mask
Speed
.
Installing the Avaya S8500 Media Server with an Avaya G650 Media Gateway
Corporate LAN field to Ethernet 2 to have the IPSI control on
Successfully configured
December 2003